Hilti TE DRS­6-A Manual De Instrucciones página 21

7 Transport and storage of cordless tools
Transport
CAUTION
Inadvertent starting during transport. Uncontrolled starting during transport may
occur if the battery is fitted, thereby resulting in damage to the tool.
▶ Always remove the battery before transporting the tool.
▶ Remove the battery.
▶ Transport the tool and batteries individually packaged.
▶ Never transport batteries in bulk form (loose, unprotected).
▶ Check the tool and batteries for damage before use after long periods of transport.
Storage
CAUTION
Inadvertent damage caused by defective battery. A leaking battery may damage
the tool.
▶ Always remove the battery before storing the tool.
▶ Store the tool and batteries in a place that is as cool and dry as possible.
▶ Never store batteries in direct sunlight, on heating units or behind a window pane.
▶ Store the tool and batteries in a place where they cannot be accessed by children or
unauthorized persons.
▶ Check the tool and batteries for damage before use after long periods of storage.
8 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy
the problem by yourself, please contact Hilti Service.
8.1 Troubleshooting
Trouble or fault
An excessive amount of
dust is generated.
The drill bit is not cen-
tered in the suction
head.
Printed: 21.10.2016 | Doc-Nr: PUB / 5071244 / 000 / 04
Possible cause
The dust container is full.
The filter is defective.
The suction head is defec-
tive.
The suction head brush is
worn.
The dust removal module is
not fitted correctly.
Action to be taken
▶ Empty the dust container.
▶ Replace the filter.
▶ Change the suction head.
▶ Change the suction head.
▶ Push the dust removal
module on to the tool until
it engages.
English 15