Listo CAL170-60B1 Manual De Utilización página 21

Use the following tools:
1 Phillips screwdriver 1 flat screwdriver
1. Unscrew the hinge cover.
2. Open the door, and unscrew and remove the
upper hinge. Then remove the door and place
it on a soft surface to avoid scratching it.
3. Remove the protective cover at the top of the
appliance as well as the screws, and switch
them to the right side.
V.1.0
1 x 8 mm socket spanner
and
1 x 10 mm socket spanner
40
4. Carefully tilt the freezer backwards and
place it on a stable surface. Carry the device
with another person. First remove the two
adjustable feet. Then, unscrew the lower hinge
of the door as well as the base of the left foot.
Warning: if there is a screw at the front of the
left corner, remove it before fitting the hinge.
5. Unscrew and remove the pivot pin from the lower hinge, turn the mount over and
put the entire unit on the other side.
Dévissez
6. Fit the bottom hinge on the left side and the
base of the foot on the right side. Then screw
the two adjustable feet back on.
7. Unscrew the pivot pin from the upper hinge,
and screw it back on the left side.
Vissez
41 V.1.0