GRAPHITE 59G093 Manual Del Usuario página 21

EQUIPMENT AND ACCESSORIES
1. Grinding wheel guard
2. Socket spanner
3. Additional handle
ATTACHING THE ADDITIONAL HANDLE
The additional handle (3) is installed in one of the holes in the grinder head. It is recommended to use the
grinder with the additional handle. When holding the grinder with both hands (also using the additional
handle), there is less risk of touching the grinder wheel or brush with your hand, as well as of injuries during
recoil.
INSTALLING AND ADJUSTING THE GRINDING WHEEL GUARD
The wheel guard protects the operator against flying broken pieces and accidental contact with a
working tool or sparks. The guard should always be fitted. Special attention should be paid so that
its covering part faces the operator.
Install the grinding wheel guard (4) so the protrusion on its clip matches the notch on the grinder gear
casing.
The wheel guard can be set in any position.
Secure the mounting bolt.
The removal and adjustment of the wheel guard are performed in a reverse order to its installation.
REPLACEMENT OF WORKING TOOLS
When working tools are replaced, wear working gloves at all times.
The spindle lock button (1) is only designed to lock the grinder spindle, when a working tool is
installed or removed. Do not use it as a braking button, when the wheel rotates. Otherwise, the
grinder may become damaged or the user may be injured.
INSTALLING THE WHEELS
When grinding or cut-off wheels with the thickness below 3 mm are installed, the outer flange nut (5)
should be tightened with the flat surface from the wheel side (fig. B).
Press the spindle lock button (1).
Insert the special key (included) into two holes of the outer flange ( 5) (fig. A).
Rotate the key to loosen and remove the outer flange ( 5).
Place the wheel so it is pressed against the surface of the inner flange ( 6).
Tighten the outer flange ( 5) and slightly tighten it with the special key.
The wheel is removed in the reverse order. During installation, the wheel should be pressed against the
surface of the inner flange (6) and seated centrally in the neck.
INSTALLING THE WORKING TOOLS WITH THREADED HOLES
Press the spindle lock button (1).
Remove a previously installed working tool, if it is installed.
Both flanges should be removed before installation – the inner flange ( 6) and outer flange (5).
Put the threaded part of a working tool onto the spindle and slightly tighten.
Working tools with threaded holes are removed in the reverse order.
INSTALLING THE ANGLE GRINDER ON A TRIPOD FOR ANGLE GRINDERS
The angle grinder can be used on a dedicated tripod for angle grinders, provided that it is correctly installed
according to instructions of the manufacturer of a tripod.
- 1 pce
- 1 pce
- 1 pce
PREPARATION FOR WORK
21