Assembling The Long-Handled Hedge Trimmer; Operating The Hedge Trimmer; Swivelling Out The Blade Beam - Grizzly Tools EHS 900-2 L Manual Del Usuario

Assembling the Long-
Handled Hedge Trimmer
Pull out the power plug before car-
rying out any work on the equip-
ment.
Use only original parts.
B 1. Unpack the device and check it
for completeness.
2. Slide the front arm (7) of the
long-handled hedge trimmer
onto the tubular shaft of the
long-handled hedge trimmer
and turn slightly. The safety
button (8) then locks into place.
Fix the two shaft elements to
the star wheel (9). Screw the
nut onto this from the threaded
rod on the star wheel (9) and
place it sideways in the holder
on the tubular shaft. With the
star wheel, push the threaded
rod (9) through the tubular shaft
and screw the star wheel (9)
together with the nut.
C
3. Assemble the leg protection for
right-handed users in variant a).
For left-handed users, assemble
the leg protection rotated in vari-
ant b) as per the illustration.
Move the barrier bracket either
to position a) or b) on the mount-
ing block (30). Insert the screws
(32), each together with a
washer (31), through the aligned
holes and screw the barrier
bracket using the Allen key (41)
supplied to the round handle
(10) until it lies flat against this.
Place the round handle (10) on
the tube. Fold on the counter-
holder (40) of the round handle
and screw it on together with the
large washer (38) with the rotary
knob (39).
Operating the Hedge
Trimmer
Do not use the equipment without
the hand guard. Wear suitable
clothing and work gloves when
working with the equipment.
Ensure that the equipment is
functional before each use. The
On/Off switch and the safety
switch must not be held closed.
They must switch off the motor
when on is released. Should a
switch be damaged, stop working
with the equipment. Ensure that
the mains voltage value matches
the label on the equipment.
Note noise protection and local
specifications.

Swivelling Out the Blade Beam

1. Hold the safety blade beam
D
( A 1) on the handle to adjust the
blade beam (6).
2. Unscrew the stop lever fixing (4)
from the stop lever (5a).
3. Unlock the stop lever (5a) by
pressing the safety lever (5b).
Press simultaneously on the safe-
ty lever (5b) and stop lever (5a)
to release the safety blade beam
fixing ( A
4. The safety blade beam (
can now be swivelled out into the
operating position. Use the stop
stages and allow the stop lever
(5a) and safety lever (5b) to click
back in.
5. Screw the stop lever fixing (4)
back into the stop lever (5a).
The angled-in blade shaft is a trans-
port and storage position. For work
with the equipment, the blade shaft
can be angled up to max. 90°.
GB
1).
A 1)
91