Safety Information - Nexxt Solutions Corregido V2 Guia Del Usuario

User guide
Thank you for purchasing the Smart oodlight Wi-Fi
camera from Nexxt Solutions. We are excited in being a
part of making your life easier, safer and bringing peace of
mind inside and outside your home.

Safety information

Precautions
Please read and understand this entire manual before
attempting to assemble, install and operate this smart light
xture.
This smart light xture requires 110-220 volt AC.
Installation and wiring should be performed by a quali ed
electrician. Do not attempt to perform installation if you
are not familiar with hardwired electrical connections.
Improper installation can lead to loss of warranty.
This smart light xture must be properly grounded.
This light xture is intended for use with the enclosed
gasket and with a junction box marked for use in wet
locations.
For proper operation, this smart light xture should be:
- Installed outdoors to a wall or eaves
- Installed 8ft. (2.4m) above the ground (if the light xture is
mounted higher than recommended height , aiming the
sensor down will reduce the coverage area.)
Turn the power o at the circuit breaker or fuse.
Place tape over the circuit breaker switch and
verify power is o at the light.
WARNING: Risk of re. Keep the bulbs at least 2in
(51mm) from combustible materials.
WARNING: Keep the motion sensor at least 1in
(25mm) away from the bulbs.
WARNING: To avoid water damage and risk of
electric shock, the motion sensor control must be
facing the ground when installation is complete.
WARNING: Burn hazard. Allow the light xture
and the bulb to cool before touching
WARNING: Do not connect the light xture to a
dimmer switch or timer.