Trimming The Insoles To Size; Charging The Battery Pack - Crivit CEB 2000 A1 Instrucciones De Uso

Trimming the insoles to size

IMPORTANT
The heating element is located in the region of the toes.
► Under no circumstances should you cut within the warning
symbol ,as this may damage the heating element.
♦ First, select the shoes in which you wish to wear the insoles
Bear in mind that the insoles
the better the shoe is insulated against cold, the longer you
can heat with a single battery charge.
♦ The trim marks
bottom of the insoles
♦ Initially, trim the insoles
mine the required actual size by using an existing insole.
♦ Cut along the trim marks
heel and sides to your individual size.
NOTE
► In the final state the insole
and it not be possible for it to move in the shoe.

Charging the battery pack

The battery packs
ter . For safe and faultless operation of the appliance with the
electrical connection, observe the following instructions:
IMPORTANT
► Before connecting the appliance, compare the connection
data (voltage and frequency) on the rating plate with that of
your mains power supply. This data must be compatible to
avoid possible damage to the device.
► Ensure that the mains power cable is not damaged and that
it has not been laid over hot surfaces and / or sharp edges.
► Ensure that the mains power cable is not overtaut or kinked.
► Do not let the power cable hang over edges (trip wire effect).
│ GB │ IE
■ 24
are ca. 4 mm thick and that
for different shoe sizes are printed on the
and serve only as a guide for trimming.
slightly larger than needed. Deter-
and adjust the insole
should fill the entire foot bed
are charged via the supplied power adap-
at the
CEB 2000 A1
.