Vapir Vapormatic Deluxe Guia Do Usuário página 3

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 10
Instructions For Use
HERB TUBE ATTACHMENT
For best taste, we recommend following the procedure below to eliminate any
plastic tastes:
Soak tube in warm-hot (not boiling!) water for 30 minutes. Tip: Add
1
essential oils to water for better taste.
2
Remove cap by twisting top portion of unit and flipping cap over.
3
Insert warm tube through back of cap.
Insert tube through top of unit. You do not need to
4
remove the cap to do this but you can remove the cap
if you like.
Optional tube attachment is for flavor delivery purposes. Never put your mouth to
outlet valve. It may be hot. Always either use a tube or taste flavor from a distance
of several centimeters without touching the outlet valve.
Before using this unit for the first time, run it on maximum temperature and the
maximum fan speed for 2 cycles (20 minutes). This will help further eliminate any
unwanted smells from the manufacturing process.
• Insert tube before use.
• Grind herbs in our Element™, Max™ or Maxine™ Herb Grinders
(sold separately) or in a coffee grinder.
• Preheat Vapormatic Deluxe™ to 300*F/149*C with the drawer
out. Wait for the light to turn green, then insert the disk drive.
• Inhale the flavor immediately upon insertion.
• When inhaling, breathe deeply. Hold the vapor in. Repeat for
10-15 minutes.
• Remember, visible vapors will not always be present.
Instructions For Balloon Inflation Kit
CUT THE TUBE TO 3" INCHES - 4" INCHES FOR BEST RESULTS
WHEN USING WITH THE BALLOON.
This Vapormatic Deluxe Vaporizer is equipped with a new supercharged heater.
Changing the fan speed may or may not noticeably affect the temperature. It
is not necessary to heat up your unit to the maximum temperature to inflate
balloons. Please use a moderate temperature between 120C/250F and 176C/350F
when preheating your unit. Using a higher temperature may cause burning of
your herbs.
When using a higher temperature we advise the use of a higher fan speed for
optimal vaporization.
FAN SPEED SETTING
HIGH= 1-10
MEDIUM = 10-15
FOR EFFECTIVE BALLOON INFLATION:
1
Preheat the unit to the desired temperature .
2
Connect balloon with tube attached to the vapor outlet valve.
3
Insert disc and set the fan to a high speed .
Prepare a second balloon so you can place it directly on the valve when the
4
first one is filled.
5
Repeat filling balloons until flavor has diminished.
NOTE
* The quantity of balloons you inflate with vapor
from one filled disc will depend on many factors
including the condition of your herbs.
* Most vapors are invisible. As long as there is a
flavor, there is vapor.
LOW = 15-25

Publicidad

Tabla de contenido
loading

Productos relacionados para Vapir Vapormatic Deluxe

Tabla de contenido