Publicidad
Step 17
Insert three HIDDEN CAMS (2) into an ADJUSTABLE SHELF (E) as
å
shown in the lower right diagram. Fasten the ADJUSTABLE SHELF
FRONT (F) to the ADJUSTABLE SHELF (E). Tighten three HIDDEN
CAMS. Repeat this for the remaining ADJUSTABLE SHELF and
ADJUSTABLE SHELF FRONT.
NOTE: There are two sets of seven holes in each END (B1 and B2) as
å
shown to the right. If you choose to insert a METAL PIN in the third
hole from the bottom hole, then a pin must also be inserted in the
third hole from the bottom hole on the other set of seven holes in
each END (B1 and B2).
Insert eight METAL PINS (6) into the holes of your choice in the
å
ENDS (B1 and B2)..
Place the ADJUSTABLE SHELVES (E) on the METAL PINS (6).
å
B1
(8 used)
417047
B2
E
E
6
www.sauder.com
B1
1
2
The arrow must point
toward the hole in the
edge of the board.
Notch
F
E
(6 used)
6
B2
2
3
Arrow
2
Page 21
Publicidad
