Publicidad
Step 21
Insert the LARGE DRAWER into your unit by sliding the
å
EXTENSION RAILS on the ENDS (B1 and B2) into the
grooves of the LARGE DRAWER SIDES (S1 and S2) until
they are against the LARGE DRAWER FRONT (T).
Fasten the LARGE DRAWER SIDES (S1 and S2) to the
å
EXTENSION SLIDE. Use two SILVER 3/8" PAN HEAD
SCREWS (15) through the DRAWER SIDES (S1 and S2)
and into the third hole from the front as shown in the
large view.
NOTE: The screws must be started from the inside of the
å
drawer box.
Repeat this step for the small drawer.
å
417047
S1
You must start the screw
from the inside of the
drawer box and into this hole
in the EXTENSION SLIDE.
www.sauder.com
Hey! It's starting to look
like something!
S2
T
15
SILVER 3/8" PAN HEAD SCREW
(4 used in this step)
Page 25
Publicidad
