BGS technic 8849 Manual De Instrucciones página 4

REMOVAL
1. Remove shock absorber, lower mounting bolt, ABS brake sensor etc. and wedge the lower arm in
place to gain access to the bush.
2. To ensure the correct alignment is achieved mark the inner wing of the bush against the arm.
3. Lubricate generously the stud threads and bearing assembly before and during use.
4. To remove the old bush, assemble tool as shown in (Fig 1) using removal sleeve.
5. The tool should be pushing in to the centre from the outside (Fig 1).
6. Screw up the main drive bar until the thrust bearing assembly makes contact with the bush.
7. Continue to tighten slowly using a 21mm spanner or ratchet on the hex end.
8. If the bush remains stubborn, re-lubricate and try again.
INSTALLATION
1. Re-assemble the tool using the installation sleeve (Fig 2).
2. Clean the bore of the arm and re-lubricate the thrush bearing assy.
3. Position the slot on the installation tool facing towards the rear of the car. The tool should be pushing
from the centre of the car to the outside (Fig 2).
4. Ensure the bush is aligned with markings taken before removal and the bottom edge of the installing
sleeve corresponds with the contoured shape of the trailing arm.
5. Hand tighten as before until the thrust bearing contacts the new bush.
6. Tighten using the 22mm tool until the new bush moves into position.
7. Continue to tighten, maintaining alignment until bush is re-housed into pre marked position.
8. Reassemble the suspension ensuring the arm is correctly aligned.
9. Clean off tool and re-lubricate.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Fig.1
Fig.2
1
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
3
2
2
4
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
1