Intended Use; Safety Precautions - BGS technic 8849 Manual De Instrucciones

TOOLS
1 Main Drive Bar
2 Thrust Bearing Assembly
3 Removal Sleeve
4 Installing Sleeve

INTENDED USE

This tool set is made for disassembly and assembly of the rear trailing arm bushes. Removal and
installation of bushes can be done directly on the car. This tool set is suitable for following models:
Ford Focus MK1 & MKII (1998-2007), Kuga (< 2008), C-Max (2007) / Mazda 3 Saloon / Hatchback (BK)
(2003-2008), Mazda 5 (CR, CW), Mazda MPV (2005) / Volvo V50 Hatchback (2004-2012), Volvo S40 MK2
Saloon (2003-2012).

SAFETY PRECAUTIONS

•
Always wear appropriate safety equipment.
•
Refer to a reputable workshop manual and follow the detailed instructions relevant to the vehicle
being serviced.
•
Always ensure the car is securely supported by axle stands or ramps with the remaining wheels
chocked and hand brake on.
•
Prepare the existing bush joint before attempting to remove it.
•
Clean off all rust, grime etc. and prime with penetrating oil.
•
Leave the oil to soak in for quite a while before attempting to remove.
•
Inspect the tool prior to use and replace worn and damaged parts.
•
Lubricate the threads on the centre screw before and after use.
•
Care should be taken to align the bush and housing correctly.
•
Do not apply excessive force.
•
Do not use with an impact wrench.
•
Use common sense and caution at all times..
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Rear Trailing Arm Bush Tool
for Ford, Mazda, Volvo
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
Art. 8849
1
2
4
3
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed