Festool BS 105 Manual De Instrucciones página 12

Customer service and repair. Only
through manufacturer or service work-
shops: Please fi nd the nearest address
at:: www.festool.com/Service
Use only original Festool spare parts!
EKAT
4
Order No. at: www.festool.com/Service
5
3
2
1
Always keep the machine and the ventilation slots
clean.
The tool is fi tted with special motor brushes with
an automatic cut-out. When the brushes become
worn the power supply is shut off automatically
and the tool comes to a standstill.
The sanding base (3.4) must be replaced if the
graphite coating is worn. Unscrew the three
screws (3.2) and remove the retaining strip (3.3).
7 Accessories, tools
The order numbers of the accessories listed below
can be found in the Festool catalogue or on the
Internet under "www.festool.com".
Sanding base
A sanding base specially designed for heavy-duty
sanding work and maximum material removal is
available.
Sanding belts
- Synthetic-resin bonded X fabric sanding belts:
sanding wood, fi breboard, iron, sheet steel, non-
ferrous metals and light alloy.
- Combination sanding belts: removing coatings
and concrete residues, sanding plastered sur-
faces.
8 Disposal
Do not throw the power tool in your household
waste! Dispose of the machine, accessories and
packaging at an environmentally-responsible
recycling centre! Observe the valid national regu-
lations.
EU only: In accordance with European Directive on
waste electrical and electronic equipment and im-
plementation in national law, used electric power
tools must be collected separately and handed in
for environmentally friendly recycling.
Information on REACh: www.festool.com/reach
12