Publicidad
Idiomas disponibles
Idiomas disponibles
Gobo Zoom™ LED 2.0 QRG
AC Power
Fuse Replacement
Mounting
Product
Mounting
Diagram
DIP Switches
DMX Linking
Starting Address
DMX Values
2-CH
Channel Function
This product has an auto-ranging power supply that can work with an input
voltage range of 100~240 VAC, 50/60 Hz.
1. Disconnect the product from power.
2. Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.
3. Pry the safety cap out of the housing.
4. Remove the blown fuse from the clip on the front of the safety cap and
replace with a fuse of the exact same type and rating.
5. Re-insert the fuse holder and reconnect power.
Before mounting this product, read the Safety Notes.
The DIP switches on the rear panel of this product allow for both standalone
and DMX operation. To configure DIP switches for DMX operation: 1
determine the starting address, 10 activates DMX mode. For standalone
operation and more details on DIP switches, consult the User Manual at
www.chauvetlighting.com.
The Gobo Zoom™ LED 2.0 can work with a DMX controller. Instructions
for connecting and configuring this product for DMX operation are in the
User Manual. If you are not familiar with DMX or DIP-switch configuration,
download the DMX Primer from www.chauvetlighting.com.
To ensure full access to the two channels available in DMX mode, the
highest recommended DMX address is 511.
1
Dimmer
2
Gobo Rotation
Value
Percent/Setting
000 255 0~100%
000 255 Slow to fast
4
EN
9
~
Publicidad
