Removalfrom Window - Sears Kenmore 580.76129 Manual Del Propietário

J_J FRONT INSTALLATION
Install the front grille(packed separately) onto the
cabinet as forlows:
• Hook upper tabs of front grille into slots on the
cabinet top, (FIG. 19)
• Push front grille's tips towards the cabinet in order
to snap side tabs into the cabinet. (FIG. 19)
• Open the inlet grille. (FIG. 20)
• Install the screw (ITEM E) through the front grille.
(FIG. 20)
• Close inlet grille. (FIG. 21)
Front Installation
-Inlet grille
Front Installation FIG. 20
Front Installation FIG. 21
_']IF AIR CONDmONER IS BLOCKED BY
STORM WINDOW FRAME
• If storm window presents interference, fasten a 2"
wide wood stripto the inner window sill across the full
width of the sill.The wood stdp should be thick
enough to raise the height of the window sill so that
the unit can be installedwithoutinterference from the
the storm windowframe. See FIG. 22.
Top of wood strip should be approximately 3/4"
higher than the storm window frame to help
condensation to drain properly to the outside.
• Install a second wood strip (approximately 6" long by
1V2" wide and same thickness as first strip) in the
center of the outer sill flush against the back of the
inner sill. Screw the L brackets into this strip.
This will raise the L bracket as shown in FIG. 22.
1 1/2" min.
WOOD STRIP MOUNTED (38rnm)
ON TOP OF INNER SILL --I_- 3/4" ,
INNER FRAME
SILL
OUTER
SILL
TSIOE
FIG. 22
REMOVAL FROM WINDOW
• Turn offandunplugthe air conditioner,
• Removethe frontgrille.See HOW TO REMOVE THE
FRONT GRILLE, Referto page 13.
• Unscrew the side screws that you installed in Step 15.
• Slide the air conditioner out of the cabinet.
BE CAREFUL NOT TO DROP IT. Hold onto it firmly the
whole way sliding it out. Once removed, set it safety out
of the way.
• Remove the L bracketfrom window frame and the sash
seal from between the windows.
• Unscrew the side curtains from the window frame. Fold
them back to the sides of the cabinet.
• Remove screws attaching cabinet to inner sill. Be careful
not to let cabinet fall oncescrewsere removed.
• Remove cabinet from window opening.
• Place air conditioner into cabinet. Reinstall side screws
and Front Grille.
• Place unit and all assembly hardware in air conditioner
shipping cation, and store in clean, dry place.
• Air conditioners coveredin this manual pose an
excessive weight hazard. Two or more people
are needed to move and install the unit.
To prevent in ury or strain, use proper lifting and
carryingtechniques when movingunit.
• When handling the air conditioner, be careful to
avoidcutsfrom sharpmetalfins on front and
rear coils.
• Make sure air conditioner d oes notfall during
removal.
=
-8-