Brewing Coffee; Brew Pause Feature - Cuisinart DCC-1500 Serie Manual De Instrucciones

POWER LOSS BACKUP SYSTEM
One-minute protection in case a breaker trips, the
unit is unplugged, or the power fails. It holds all
programmed information, including time of day,
Auto On time and Auto Off time.
ADJUSTING THE AUTO OFF FEATURE
After the coffeemaker finishes a brew cycle,
the heating plate underneath the carafe is
programmed to keep your coffee warm for 2
hours (default time) and then automatically shut
off. The Auto Off feature can be adjusted so that
the keep warm time can last between 0-2 hours.
To change the automatic shut off time, follow the
instructions below:
1. Press and hold the BREW/OFF button for two
seconds, until the blue BREW/OFF indicator
and the clock display begin flashing.
2. The LCD display will show the program default
time at 2:00, and will be flashing.
3. Press the HOUR and MINUTE buttons to
program your coffeemaker to automatically
shut off from 0-2 hours.
Note: The Auto Off time ca n only be programmed
before brewing.

BREWING COFFEE

Before your first brew, please follow
instructions in previous page - Before Brewing
Your First Pot of Coffee.
1. Insert charcoal water filter
Follow directions for
the preparation and
insertion of the filter
on previous page.
2. Fill the water
reservoir
Open the coffeemaker
reservoir cover by
lifting it up. Pour in
the desired amount
of water using the
stair step water level
indicator located in the
reservoir.
3. Insert filter and add
the ground coffee
Remove the filter
basket by grasping
the handle and lifting
straight up. Insert
a #4 paper filter or
permanent nylon filter.
Be sure that a paper
filter is completely
open and fully inserted
in the basket. It may
help to fold and flatten
the seams of a paper
filter beforehand. Add
1 level scoop (1 tablespoon) of ground
coffee per cup. Adjust the amount
according to taste.
NOTE: The maximum capacity for ground
coffee is 15 scoops (15 tablespoons) for
this coffeemaker. Exceeding this amount
may cause overflow if the coffee is too
finely ground.
Replace the filter basket in the filter basket
holder and press firmly on cover to be sure it
closes securely.
4. Before brewing coffee
Make sure the glass carafe is in position on
the heating plate and the top cover is closed.
5. Begin brewing
Press the BREW/OFF button, and the blue
indicator light will turn on. Or, set the Auto
On function (see page 7) and the Auto On
indicator light will turn on.
NOTE: Press and release the BREW/OFF
button again to turn off brewing at any time.
6. When the brewing cycle is complete, 5 beeps
will sound. Coffee will continue to stream from
the filter for several seconds.
7. After brewing cycle is complete, coffeemaker
will enter Keep Warm function. Heating plate
will keep carafe warm for up to 2 hours.
NOTE: Reservoir cover may be hot during
and directly after brewing. Wait at least 10
minutes before opening.
BREW PAUSE
This feature interrupts the flow of coffee from the
basket to let you pour that first cup mid-brew.
Because the flavor profile of coffee brewed at the
start of a cycle differs from that brewed toward the
end, be aware that using this feature will weaken the
flavor strength of the finished pot.
NOTE: Removing carafe for more than 20 seconds
may cause filter basket to overflow.
8
™
FEATURE