Safety Device; Maintenance And Service - DeLonghi TRRS0715E-6A Manual De Instrucciones

. The hours left before the appliance goes to stand-by
mode, the power level and in case the function selected
are displayed together with the
flashing (see fig. 3).
Change the hours using the + and - buttons, then wait a few
seconds for the program to be stored. The current settings
and symbol are displayed. At the end of the set time the
appliance switches to standby mode automatically. To go
back to operating without the timer, press the timer button
twice. The timer symbol
Please note: the time is settable from 0.5 to 24 hours.
Change of the temperature scale
The display can show the temperature in both °F and °C.
To select the desired temperature scale, when the unit is in
standby position, press and hold the "+" and "ECO" keys for
at least 10 seconds, then release.
The change of scale will be indicated by two short beeps.
Brightness of the display
The appliance allows two different brightness settings for the
display.
The highest is active when any key button is pressed. After
a few seconds of key board inactivity, the brightness will
decrease to the operating brightness level. This lower level
can be adjusted in this way:
- with the appliance in on mode after pressing for 5
seconds the ECO button the display will show (see fig. 4):
Fig. 4
With the + and - button is possible to select the desired
-
brightness (three brightness levels available).
- After 5 seconds without to press any button, the
brightness level will be memorized and the operating
conditions will be the same ones previously set.
symbol and "h" symbol
disappears from the display.
Alarms
The appliance has a diagnostic system that makes it possible
to signal malfunctions.
In case of problems, the display will show an alarm message:
- (Probe Failure) blinking
With this alarm the appliance does not operate. Contact
the De'Longhi Customer Service.
- (High temperature)
When the product's internal temperature is too high,
the heating power will progressively and automatically
be reduced.
The display shows
remove the cause of this alarm check that the unit is not
covered and let the appliance cool down.

SAFETY DEVICE

A safety device switches the appliance off in the event of
overheating. To restart the appliance, contact the De longhi
toll free number.

MAINTENANCE AND SERVICE

Always remove the plug from the power outlet and allow the
appliance to cool. Wipe appliance with a soft damp cloth, do
not use detergents and abrasives.
Should the appliance not be in use over a certain length of
time, wrap the cord around the cord holder and store it in a
dry place. This appliance has been built to give many years
of trouble free service. In case of malfunction or doubt, do
not try to repair the appliance by yourself: this may result in
a fire hazard or electric shock. Contact the De longhi toll free
number.
7
for two seconds, blinking. To