Publicidad
1�
Connect
Before You Begin
Make sure you have the following:
•
An active Network connection
•
Active Internet phone service accounts and settings (if connecting to Internet phone service)
•
A cable/DSL modem (if connecting to Internet)
•
One computer for configuration of the Gateway or an analog telephone with an RJ-11 phone
cable
NOTE:
do not need to change any of the default voice settings . Refer to
the documentation supplied by your service provider for more
information .
A.
Power off your network devices,
including your modem and PC .
B.
If you have an RJ-21 connector
available, you can connect to
the RJ-21 port on the back of the
Gateway . Then skip to step E . If you
are connecting individual phone
lines, go to step C .
C.
Connect one end of an RJ-11 phone
cable to the Gateway's PHONE 1
port . Connect the other end to your
analog telephone .
D.
Repeat Step C with each PHONE
port if you have an additional
telephones to connect .
4
If the Gateway is pre-configured by your ITSP, then you
RJ-21 Connection
RJ-21 Connection
RJ-11 Phone port
RJ-11 Phone port
Publicidad
