Publicidad
3�
Interactive Voice Response Menu
This section explains how to use the Interactive Voice Response Menu to
configure the Gateway's network settings . You will use the telephone's keypad
to enter your commands and select choices, and the Gateway will use voice
responses .
To access the Interactive Voice Response Menu:
A.
Use a telephone connected to the PHONE port of the Gateway . (You can
only access the Interactive Voice Response Menu through an analog
telephone, not any of the Internet phones .)
B.
Press **** (in other words, press the star key four times) .
C.
Wait until you hear the "Linksys configuration menu—please enter the
option followed by the # (pound) key or hang up to exit" response .
Refer to the following table that lists actions, commands, menu choices, and
descriptions . After you select an option, press the # (pound) key . To exit the
menu, hang up the telephone .
Using the Interactive Voice Response Menu
While entering a value, such as an IP address, you may exit without entering any
changes . Press the * (star) key twice within half a second . Otherwise, the * will
be treated as a decimal point or dot .
After entering a value, such as an IP address, press the # (pound) key to indicate
you have finished your selection . To save the new setting, press 1 . To review the
new setting, press 2 . To re-enter the new setting, press . To cancel your entry
and return to the main menu, press * (star) .
For example, to enter the IP address 191 .168 .1 .105 by keypad, press these keys:
191*168*1*105 . Press the # (pound) key to indicate that you have finished
entering the IP address . Then press 1 to save the IP address or press the * (star)
key to cancel your entry and return to the main menu .
If the menu is inactive for more than one minute, the Gateway will time out . You
will need to re-enter the menu by pressing **** .
The settings you have saved will take effect after you hang up the telephone .
The Gateway may reboot at this time .
8
Publicidad
