Philips Norelco 7500 Serie Manual De Instrucciones página 3

- Unplug power cord before plugging in or
unplugging the product.
- Only use the power cord and other
accessories supplied with the product.
- Do not attempt to open the product to
remove or replace the built-in
rechargeable battery.
- The batteries used in this product may
present a fire or chemical burn hazard if
mistreated. Do not disassemble, heat
above 100 °C (212 °F) or incinerate.
IMPORTANT: The power plug contains a
transformer. Do not cut off the power plug
to replace it with another plug as this will
cause a hazardous condition.
SAVE THESE
INSTRUCTIONS
Introduction
Congratulations on your purchase and
welcome to Philips Norelco!
To fully benefit from the support that
Philips Norelco offers, register your product
at www.norelco.com/register.
General description (Fig.1)
1 Cutting element
2 Vacuum system
3 Length setting display
4 Zoom wheel
5 On/off button
6 Battery status indicator
7 Pouch
8 Power plug
9 Small plug
10 Detail comb 3mm (M)
11 Detail comb 5mm (L)
12 Precision trimmer
13 Beard comb
Not shown: cleaning brush, cleaning sponge
Display
Battery status indicator
When the battery is almost empty, the
bottom light of the battery status indicator
flashes orange.
When the product is charging, first the
bottom light flashes white, then the second
light, and so on. When the battery is fully
charged, all lights light up white
continuously.
Note: The lights switch off automatically
after 30 minutes.
Remaining battery capacity
The remaining battery charge is shown by
the lights of the battery charge indicator
that light up continuously.
Length settings
The selected length setting is shown on the
display above the zoom wheel when you
select the desired hair length setting with
the zoom wheel.
Charging
Charging takes approx. 1 hour. Charge the
product before first use and when the
bottom light of the battery status indicator
flashes orange.
1 Make sure the product is turned off.
2 Put the small plug in the product and put
the power plug in the wall outlet (Fig. 6).
3 After charging, remove the power plug
from the wall outlet and pull the small
plug out of the product.
When the product is fully charged, it has a
cordless operating time of up to 120
minutes.
Quick charge
When the battery is empty and you connect
the product to the wall outlet, the battery
charge indicator flashes quickly. When the
product contains enough energy for one
trimming session, the battery charge
indicator starts flashing white slowly.
Quick charge takes approx. 5 minutes.
Charging in the charging stand
1 Put the small plug in the charging stand
and put the power plug in the wall outlet.
2 Put the product in the charging stand.
3 After charging, remove the power plug
from the wall outlet and pull the small
plug out of the charging stand.
Note: The product can also be charged
with the power plug.