Removing And Attaching The Control Element; Functions - Crivit PG-02 Instrucciones De Uso

Remote control SP-11
(Fig. J).
• Also reinstall the rubber covers and the brakes properly on your handlebars if
necessary.

3. Removing and attaching the control element

Never leave the control element of your remote control unattended on your handlebars. The
remote control has a bayonet catch. Release the control element as follows (Fig. J):
• Turn the upper control element anticlockwise until it is diagonal to the bracket.
• Remove the control element of the remote control and keep it with you.
Reattach the control element to the bracket on the handlebars before use as follows:
• Place the control element of the remote control diagonally onto the handlebar
attachment. Be careful to attach the control element in the correct position, meaning
the ON/OFF button must always be readable while travelling and may not be upside
down.
• turn the control element of the remote control clockwise on the handlebar attachment
until it locks into place and sits firmly
Caution: Keep your remote controls with you and do not leave them
unattended on the handlebars. When attaching the control element
to the handlebars, please ensure that you attach this correctly and
that you will be able to read the writing while travelling.

4. Functions

To be able to use the functions of the remote control in connection with the helmet, start the
remote control by pressing the ON/OFF switch.
Now, you can control the back light and the indicators via the remote control attached to the
handlebars.
The remote control displays which function is active by illuminating the respective button.
The remote control has 4 functions:
• ON-/OFF
• Left indicator light
• Right indicator light
• Back light
To switch off the remote control, hold the ON/OFF switch for a few seconds until the light
goes out.
181206_CO-1324_LB09_BDA_GG.indd 9
9
03.01.2019 08:27:41