Troubleshooting; Introducción - Philips Steam Plus FC7020/71 Manual De Instrucciones

ENGLISH
Introduction
Congratulations on your purchase and welcome to Philips! To fully benefit
from the support that Philips offers, register your product at
www.philips.com/welcome.
Important
Read this important information carefully before you use the appliance and
save it for future reference.
Danger
- Never immerse the appliance in water or any other liquid, nor rinse it
under the tap, except for the parts that can be removed for cleaning
according to the instructions.
- Beware of hot steam that comes out of the appliance. Steam may cause
scalding (Fig. 1).
- To avoid a hazard, do not move the appliance over its own mains cord
or the mains cords of other appliances.
Warning
- Check if the voltage indicated on the appliance corresponds to the local
mains voltage before you connect the appliance.
- Do not use the appliance if the plug, the mains cord or the appliance
itself shows visible damage, or if the appliance has been dropped
or leaks.
- Always return the appliance to a service centre authorised by Philips for
examination or repair. Do not attempt to repair the appliance yourself,
otherwise the guarantee becomes invalid.
- If the mains cord is damaged, you must have it replaced by Philips,
a service centre authorised by Philips or similarly qualified persons in
order to avoid a hazard.
- Never leave the appliance unattended when it is connected to the mains.
- This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of experience
and knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.
- Keep the appliance, the descaling pin and the mains cord out of the
reach of children when the appliance is switched on or is cooling
down (Fig. 2).
- Children should be supervised to ensure that they do not play with
the appliance.
- The nozzle of the appliance can become extremely hot and may cause
burns if touched.
- Always unplug the appliance and let it cool down for at least 60 minutes
before you clean it or before you attach or detach the pad and pad
holder, the roller brush, the dust container and the filter and before you
unclog the steam opening with the descaling pin.
- The water tank has a capacity of 0.4 litres. Never fill the water tank with
more than this amount.
- Never store the appliance at a temperature lower than 0°C.
- Never direct the hot steam from the nozzle at people or pets (Fig. 3).
Caution
- Only connect the appliance to an earthed wall socket.
- Do not use the appliance on the same spot too long, as this may
damage the floor.
- Do not use the steam function on wood or laminate floors without a
water-resistant top coat or whose water-resistant top coat is damaged.
The steam may remove the sheen of wax-treated wooden floors.
Always test an area out of direct view to make sure the floor can be
cleaned with hot steam. We also advise you to check the maintenance
instructions from the floor manufacturer.
- When you have finished steaming, always switch off and unplug
the appliance and let the appliance cool down for 60 minutes.
- This appliance is intended for indoor household use only.
- Steam may damage or cause discolouration of certain surfaces.
Type of water to be used
- Your appliance is designed to be used with tap water. If you live in an
area with hard water, fast scale build-up may occur. In that case,
use distilled water to prolong the life of your appliance.
- For optimal cleaning results, use distilled water.
- Do not put detergents, perfume, vinegar, starch, descaling agents, ironing
aids or other chemicals in the water tank, as your appliance is not
designed to work with these chemicals.
- To prolong the life of the appliance, replace the descaling filter every
6 months.
Carpet glider
Note: The carpet may be a bit wet right after you clean it.
- With the carpet glider you can lightly steam carpets and rugs.
This allows you to sanitise and freshen up your carpets and rugs.
- The first time you use the carpet glider, we advise you to clean a small
or non-visible area of the carpet or rug to make sure it is not damaged
by steam. Alternatively, you can also check the manufacturer of the
carpet or rug if it is suitable for cleaning with steam.
Electromagnetic fields (EMF)
This appliance complies with all applicable standards and regulations
regarding exposure to electromagnetic fields.
Ordering accessories
To buy accessories or spare parts, visit www.shop.philips.com/service
or go to your Philips dealer. You can also contact the Philips Consumer Care
Centre in your country (see the worldwide guarantee leaflet for contact details).
- You can order a set of a new filter and two new pads under type
number FC8056 (Fig. 4).
Recycling
Do not throw away the appliance with the normal household waste at
the end of its life, but hand it in at an official collection point for recycling.
By doing this, you help to preserve the environment.
Guarantee and support
If you need information or support, please visit www.philips.com/
support or read the separate worldwide guarantee leaflet.

Troubleshooting

Problem Cause
The You did not
appliance switch on
does not the steam
steam. function.
The boiler
has not
heated up
yet.
There is no
water in
the water
reservoir.
The steam
opening is
clogged.
The filter is
clogged.
The handle
is not at the
right angle.
The roller You have not
brush does pressed the
not rotate. pedal on the
nozzle.
I cannot pull The
the handle appliance is
towards me. still in parking
position.
ESPAÑOL
Introducción
Enhorabuena por la compra de este producto y bienvenido a Philips.
Para sacar el mayor partido de la asistencia que Philips le ofrece, registre su
producto en www.philips.com/welcome.
Solution
Switch on the steam function by pressing
the steam button on the front of the
appliance.
When you press the steam button, the
boiler starts heating up. After approx.
30 seconds the appliance is ready for
steaming. The ring around the steam
button lights up blue.
Fill the water reservoir and put it back
into the appliance.
Over time minerals in the water cause
scale to build up in the steam opening.
Use the descaling pin supplied with the
appliance to remove scale and other
residues from the steam opening.
Over time minerals in the water cause
scale to clog the openings in the filter.
You have to replace the water filter every
6 months.
To operate the appliance and use the
steam function, you have to pull the
handle towards you.
To clean the floor with the roller brush,
press the grey pedal on the side of the
nozzle.
To unlock the appliance from parking
position, place your foot on the nozzle and
pull the handle towards you. This releases
the appliance from its parking position.