Tripp-Lite SRCOOLNET2 Guía De Instalación E Inicio Rápido página 7

Installation
4-4
Configure SRCOOLNET2 in Terminal Mode: Note: The SRCOOLNET2 must be
reinitialized by pressing the reset button (located between the "Link" and "Status"
descriptions under the RJ45 port on the SRCOOLNET2), for 3 seconds. After the
reset, an initialization page should appear in the terminal emulation program.
When the message below appears, press any key on the keyboard within 5
seconds. If the 5-second period has elapsed, you can reinitialize the
SRCOOLNET2.
Press any key in 5 seconds to change these settings.
Follow the sequence of responses below in order to assign a static IP address to
the SRCOOLNET2.
The default root password is TrippLite. Sample IP settings are shown – supply
your own IPv4 or IPv6 information when you configure your SRCOOLNET2.
When the message below appears, enter 'm' to modify the SRCOOLNET2's
settings.
Press A to Accept the settings,
or M to Modify? m
Enter the root password: *********
Reset configuration and root password to default values? n
For each of the following questions, you can press <Return> to select the value
shown in braces, or you can enter a new value.
ETHERNET INTERFACE SETTINGS:
Obtain IPv4 settings automatically using DHCP for Ethernet interface [Y]? n
IP address
IP address IP address is 192.168.1.2
Subnet mask
Gateway address
Gateway address IP address is 192.168.1.1
Enable DHCPv6 for the Ethernet interface [N]?
Enable static IPv6 for the Ethernet interface [N]? y
15-02-247-93342E.indb 7
[10.1.0.165]? 192.168.1.2
[255.255.255.0]?
[10.0.0.1]? 192.168.1.1
7
4/9/2015 9:52:08 AM