ENGLISH
location of installation
Install your Dompel product in a level place with no grooves or splices,
preventing rocking and vibration. The location must be airy and it must not
allow straight sunlight and it must be away from sources of heat (stoves,
ovens, etc.) and flammable products. Do not install your product outdoors.
cleaning and maintenance
Do not use metal spatulas, brushes and cleaning agents such as alcohol, acetone, kerosene, gasoline, bleach,
thinner, solvents, varsol, vinegar or other chemicals or abrasives such as sandpaper or steel brushes.
The plastic parts can not be washed with boiling water. Chromed metal components can be cleaned with a
soft, dry flannel, and silicone-based automotive wax can be used to increase gloss and durability, in this case
perform the task following the wax manufacturer's instructions. Perform periodic cleaning, accumulated dust
affects the beauty of the product making it difficult to clean the product.
INSTALLATION AND ASSEMBLY
Remove all the products from the package and follow the steps below
1
Manually attach the extenders (C) to the top
of the trays (A), one on each side.
3
Fit all trays (A) manually into the tube / cable (F) one by one. Note: The number of trays varies
depending on the model chosen when purchasing.
4
Manually assemble
the base (B) on the
tube / cable (F)
6
Manually
assemble the
casters (G) on
the bottom of the
base (B). Make
sure they are
properly seated
and aligned when
resting on the
floor.
security
Avoid accidents. After
unpacking the product, keep
all the pack material out of
children's reach.
2
Fasten the extenders (C) to the bottom of
each tray (A) with philips Plastic 5 x 16 screws
(D) using a philips screwdriver or regular
screwdriver. Repeat the process on all trays.
5
Fasten the base (B) to the tube / cable (F)
with 5 x 16 plastic Phillips screws (x 02)
(E) using a philips screwdriver or a regular
screwdriver. At the end of this step, make
sure the screws are tight.
7
Manually attach the
organizer support
(H) to the top tray
(A).