How To Froth Milk - bene casa BC-99670 Manual Del Usuario

HOW TO FROTH MILK

WATER PREPERATION:
CAUTION: DO NOT remove water reservoir cap or filter until you
release the pressure in the unit. Make sure filer holder is in locked
position before use.
1. Remove the water reservoir cap.
2. Fill the stainless steel carafe to the steam line
with filtered water and pour into reservoir.
3. Screw cap back onto water reservoir.
2
FROTHING:
4. Pour in your desired amount of cold milk into a stainless
steel frothing pitcher (or ceramic mug), but allow enough
room for expansion of the foam (typically 1/3 or 1/2 of
the top).
*Frothing texture is highly dependent upon the milk type used.
2% is recommended; whole milk creates finer bubbles while
5
skim milk creates larger bubbles.
5. Place your stainless steel frothing pitcher so that the
frothing wand is submerged into the milk.
About 1/2 -1" into the milk.
6. Turn the knob to "Steam". This will take a few
seconds to heat up before bubbling. Move the pitcher in
6
a circular motion until desired amount of froth is reached.
*It takes about 2 minutes to froth 4 oz. of milk to 165 F.
7. Before removing the frothing pitcher from underneath
the frothing wand, turn the knob to the "Off" position and
remove the stainless steel frothing pitcher or mug.
6
Note: it is extremely important to clean the frothing wand after
every use. Refer to page 11 for cleaning instructions.
10
CLEANING YOUR ESPRESSO
MAKER AFTER EACH USE
Keep your Bene Casa Espresso Maker running
smoothly by cleaning it after every use.
2
1. Rinse carafe and stainless steel frothing pitcher/mug.
CAUTION: DO NOT remove water reservoir cap or filter until you release
the pressure in the unit. Make sure filer holder is in locked position
before use.
2. Remove filter holder, discard coffee grounds.
3. Rinse filter with fresh water. Please note that the filter and filter
holder are NOT dishwasher safe. Handwash only!
3
NOTE: If you did not froth milk, skip steps 4-9.
4. Fill stainless steel carafe halfway to the steam mark with water
and pour into the water reservoir.
5. Screw cap back onto the water reservoir and plug in the
machine.
6. Fill stainless steel frothing pitcher or mug half way with water
and place so that the frothing wand is submerged into the water.
4
7. Turn the knob to "Steam" and steam with water instead of
milk for 30 seconds. This will help rinse the internal parts of the
machine.
8. Once the frothing wand is cool, remove and rinse frothing
tube cover.
9. Wipe down frothing tube with a damp cloth and rinse the
frothing tube cover.
8
CAUTION: To protect against electric shock, do not
immerse cord, plug or appliance in water or other liquids.
Make sure filer holder is in locked position before use.
11