Rosewill RMS-MT6020 Manual Del Usuario página 4

TILT WALL MOUNT FOR LCD, PLASMA, and LED DISPLAYS
HARDWARE KIT
(A) M8 x 63 Lag Bolt (x4)
(B) Lag Bolt Washer (x4)
(C) Concrete Anchor (x4)
(D) M6 x 12 Screw (x4)
(E) M6 x 30 Screw (x4)
INSTALLATION
Part 1A – Mounting to the Wall (Drywall)
IMPORTANT! For safety reasons, this mount must be secured to at least two wood studs no less than 16" apart.
For displays heavier than 50 kg (110 lbs), three studs are recommended. The studs must be capable of
supporting the combined weight of the mount and display
1. Use a high quality stud finder to locate two or more adjacent studs where
you wish to install your mount. Mark both edges of each stud to help
identify the exact center.
NOTE: You must use the center of each stud to avoid cracking or splitting
the wood during installation.
2. Place the wall plate against the wall and level it using the integrated bubble
level.
3. While another person holds the wall plate in position, mark four or six
locations (two per stud) for securing the mount to the wall.
Set the wall plate aside and drill a 6 mm (1/4") pilot hole
4.
at each marked location.
5. Place the wall plate back against the wall and attach it
using the lag bolts (A) and lag bolt washers (B) provided.
Do not over-tighten these bolts and do not release
the wall plate until all bolts are in place. Ensure that
the wall plate remains level after all bolts are secured.
Part 1B – Mounting to the Wall (Concrete)
IMPORTANT! For safety reasons, the concrete wall must be capable of supporting the
combined weight of the mount and the display. The manufacturer takes no
responsibility for failure caused by walls of insufficient strength.
1. Place the wall plate against the wall in the desired location and level it
using the integrated bubble level.
2. While another person holds the wall plate in place, mark six evenly spaced
locations on the wall for securing the mount.
Set the wall plate aside and drill a 10 mm (3/8") hole at each marked location. Remove any excess
3.
dust from the holes.
(F) M8 x 12 Screw (x4)
(G) M8 x 30 Screw (x4)
(H) M6 Washer (x4)
(I) Spacer (x8)
3
RMS-MT6020 User Manual