Publicidad
Graphical operator interface type ABS CA 511, Installation guide
1 2 3 4 5
1
INSTALLATION
1.1
General information
The operator panel CA 511 communicates through the CAN-bus. The operator can
easily configure and monitor the system from the operator panel.
1.2 Installation of the operator panel
When installing the CA 511 it is required a rectangular hole with the height of
107 mm and width of 220 mm. With the CA 511 are two tin-plates and four screws
enclosed to fasten the CA 511 in the hole, see Figure 1 below.
Figure 1
Left figure, panel fasten on a door, right figure, panel with tin-plates seen on the
back with dimensions of the required hole.
1.3 Power supply
CA 511 is powered from the CAN bus cable and normally get power from PC 441.
1.4 CAN bus (Field bus)
A CAN network is of multidrop type which means that all units are connected in
parallel on the same cable.
For more detailed description see PC 441 Installation Manual.
1.4.1 CAN-socket on the CA 511
The CA 511 has a CAN bus socket. The socket is numbered from 1-5 and is con-
nected to the CAN cable as the table describes.
Pin number
1. 0V
2. CAN_L
3. CAN_SHLD
4. CAN_H
5. CAN_V+
All cables shall be connected to the CA 511.
3
220 mm (8.66 inch)
CAN/PLINT
CAN termination
switch
Cable
Description
Green
Common
White
CAN low
Shield
Cable shield
Brown
CAN high
Yellow
Positive Power supply (CA 511)
PC 441
terminals
46
45
44
43
42
EN
Publicidad
