Panasonic TY-ST85P12 Instrucciones De Instalación página 6

Assembly
Never use any other method than specified to install.
1. Preparation of supports (one each on left and right)
The weight of the pedestal is approximately 58 kg (127.9 lbs.).
For the weight of the plasma display attached to the pedestal, please see manual for the plasma display.
When mounting the plasma display, use holes  .
When using the touch panel (optional), use holes  .
1. Join display mounting fixture  to
support  using 2 display mounting
fixture hexagon bolts  and 2 flanged
cap nuts  .
Assemble so that the flanged cap nut
 is on the side of support  facing
outside.
Assemble the other side the same way.
•
The bolt should be securely tightened to
the torque given below.
(12~14 N•m)
2. Mounting of supports
1. Confirm which is the front and rear of stand
base  .
The side to which the poles are closer is the rear.
 : When the touch panel is used

Left
Flanged cap
nuts 
Display mounting fixtures 
Supports 
Display mounting fixture
hexagon bolt (with
washers) 
Poles
Front
Stand base 
Right
Flanged cap
nuts 
Rear
17