Pause Function - Daewoo DTC-400 Manual De Instrucciones

ENG
When talking over handset, press HOLD key to enter the hold mode and the hold
music is sent out. In hold mode:
1. Press HOLD key to release hold mode and continue to talk over handset, or
2. Hang up handset, it enters hands-free hold mode.
When talking at hands-free mode, press HOLD key to enter the hold mode and
the hold music is sent out. In hold mode:
1. Pick up handset to talk over handset, or
2. Press SPEAKER key to quit hold mode and talk at hands-free mode.
LOW BATTERY DETECTING
When the voltage is lower than 3.9 v, LCD displays icon to remind the user to
replace the batteries.
LCD BACKLIGHT FUNCTION
The backlight is turned on when receiving an incoming call, dialing, pressing any key
or in MUSIC HOLD mode. It will fade off if the telephone is left idle for 10 seconds.
NOTE: If batteries are not loaded, there will be no LCD backlight function.

PAUSE FUNCTION

If dial a number from PABX extension, press PABX number (normally "0" or "9") +
ALARM+ desired number. When redial, need not dial PABX number and ALARM key,
just press REDIAL key.
LOCK
Turn the key to yellow point, all numbers are locked except emergency numbers.
Turn the key to green point, all numbers starting with "0" are locked Turn the key to
red point, all numbers are allowed to be dialed out.
NOTES
Please unplug telephone line and power (if any) when installing / replacing
batteries.
TROUBLESHOOTING
- No voice
Check if the handset is on the phone or if the line has terminated.
- Receive only Check if P/T mode is properly set.
Check if the unit is locked (use the key to unlock it)
- Rusty batteries or leakage
Remove the rust or wipe away the leakage.
20