2.3.
Safety Instructions
⚠
●
Risk of electrical shock or electrocution: The electrical supply for this
robot must be installed in accordance with all applicable local codes
and ordinances. Improper installation creates an electrical hazard
which could result in death or serious injury and also cause property
damage. Replacement or repair must be carried out by the
manufacturer's after-sales service or similarly qualified persons.
● Your robot must be powered by a residual current device (RCD), connected to
earth. The residual current must not exceed 30 mA. The connection with the
branch circuit must comply with regulations (IEC 60364-1) and must be
carried out by a qualified electrician.
● This robot should only be used with the supplied control box.
● Your robot's control box must be placed at least 3.50 meters away from the
pool and at a minimum height of 2.50 meters above the edge of the pool (IEC
60364-7-702).
● The robot control box must be securely fixed to the floor or ground wall.
Never operate the unit without fixing.
● The control box and its power supply must be protected from downpours and
water in general (puddles of water type).
● This robot can be used by children aged from 8 years old and above and
persons with reduced physical, sensory or mental capacities, or lacking
experience and knowledge if they:
○ are supervised,
○ have been trained in safe use of this device,
○ understand the risks involved.
● Children must not play with the device.
● Cleaning and maintenance shall not be made by children without supervision.
⚠
●
Asphyxiation hazard: Keep small parts and packaging materials away from
children.
● Do not play with the robot or the cable: risk of accidents.
● If the floating power cable is damaged, it must be replaced by the
manufacturer's after-sales service or a qualified and trained person in order
to avoid any risk.
● Do not use the robot when people are in the pool.
● Use of your robot out of the water PROHIBITED:
○ Never plug in or switch on your robot out of the water. Switch on
when the robot is completely immersed.
○ Remove your robot from the water only if it is turned off. The robot
stops automatically at the end of its cycle. However, we recommend
that you also put it in the off position on the control box, selecting the
"0" position on the side of the box and unplug the power supply
before removing it.
○ Using your robot out of the water may cause severe damage and void
the warranty completely.
6