Troubleshooting - Wolf IR365PESPH Installation Guide

T R O U B LE S HO O T I NG

Troubleshooting

O PE RAT I O N
Range does not operate.
• Verify power is on.
• Verify electrical power to range and home circuit breaker
is on.
• Oven will automatically turn off after 12 hours of con-
tinual use, except in dehydration or Sabbath mode.
Clock display turns off.
• Clock display is in standby power mode. Refer to
page 11.
O VEN
Oven temperature issue.
• Contact Wolf customer care at 800-222-7820 for
recommendations.
No control knob display.
• Pull temperature control knob out and reinsert fully. Turn
circuit breaker off for 5 seconds, then turn back on.
No response from oven control panel touch pads.
• Turn mode selector knob to OFF to exit Sabbath mode.
• Turn circuit breaker off for 5 seconds, then turn back on.
'SAb' displayed on temperature control knob.
• Turn mode selector knob to OFF to exit Sabbath mode.
'PF' displayed on temperature control knob.
• Unit had a power outage. Turn mode selector knob to a
cooking mode, then back to OFF to reset.
• Turn circuit breaker off for 5 seconds, then turn back on.
'OE', 'OC' or other error displayed.
• Contact Wolf factory certified service.
Oven 'pops' or 'bangs' during preheat or cool down.
• Normal with new oven cavity expansion and contraction.
• Run self-clean cycle. If it persists, contact Wolf customer
care at 800-222-7820.
IN D U C TI O N SU R FAC E
Induction elements do not operate.
• Verify power is on.
• Verify electrical power to range and home circuit breaker
is on.
• Induction surface is in lock mode. Touch and hold LOCK
for three seconds to unlock surface control panel.
• Induction surface will automatically turn off after 2 hours
of continual use (high), 6 hours (medium) and 8 hours
(simmer).
Surface temperature issue.
• Contact Wolf customer care at 800-222-7820 for
recommendations.
|
wolfappliance.com 21