Cool Mode; Dehumidification Mode; Fan Mode - Black+Decker BPP05WTB Manual De Instrucciones

ENGLISH
SET UP & USE

COOL MODE

Ideal for hot weather when
you need to cool the room.
To set operation of the appliance
correctly, press the + or – buttons until
the desired temperature is displayed.
(See Fig. 7)
Then select the fan speed by pressing
the Fan Speed Button until the light
corresponding to the required fan
speed lights up:
HIGH: The Fan operates at
maximum to reach the
required temperature as
rapidly as possible.
MED: Reduces Fan noise level but
still maintains cooling.
LOW: For quiet operation.
DEHUMIDIFY
Press the "MODE" button until the
"DEHUMIDIFY" indicator light comes
on.
• Under this mode, you cannot select a
fan speed or adjust the temperature.
The fan motor operates at LOW
speed.
• Keep window and door closed for
the best dehumidifying effect.
• Exhaust hose attachment is not
required to reduce humidity,
however it is recommended in very
humid rooms so the warm air can be
exhausted outside.
DRAINING IN
Page 14

DEHUMIDIFICATION MODE

• It is recommended that the
dehumidification drain and drain
hose can be used for continuous
drainage.
• FULL TANK - When the water level
reaches a predetermined level, the
"full tank" indicator light goes on.
The unit will have to be drained.
NOTE: Refer to Water Drainage
section.

FAN MODE

• Press the "MODE" button until the
"FAN" indicator light comes on.
• Press the speed button to select
HIGH, MEDIUM or LOW fan speed.
The temperature cannot be adjusted.
• Exhaust hose attachment is not
required in this mode.
HEAT MODE
(Heat models
BPP08HWTB and BPP10HWTB only)
Press the "MODE" button until the
"HEAT" indicator light comes on.
• Press the + or – buttons to select
your desired room temperature.
The temperature can be set within a
range of 61°F-88°F.
• Press the speed button to select
HIGH, MEDIUM or LOW fan speed.
NOTE: At the beginning of this mode,
you may have to wait a few
seconds before the appliance
starts to give out hot air.