USRobotics USR9107 Guía Breve De Instalación página 7

The router starts up after you turn on the power. This may take one to two minutes.
D. See if the
troubleshooting section later in this guide.
Step 3. Install EasyConfigurator
1. Insert the USRobotics installation CD-ROM into your computer's CD-ROM drive. The
installation should start automatically. This process may take a few moments.
If the installation does not start automatically, you can start it manually as follows.
Windows Vista users: Click Windows Start > Computer. Double-click the CD drive.
Windows users: Click Start and then Run, then type D:\setup.exe in the dialogue box
and click OK. (If your CD-ROM drive uses a different letter, type that letter in place of
D.)
Macintosh users: Open the CD-ROM and double click on either MacOS X Install or
MacOS Classic Install (depending on which operating system your computer uses).
Linux users: Open the CD-ROM, browse to \platforms\linux, and double-click on
install.bin.
Select your preferred language and click OK.
2.
3. If you are using Windows, the installer runs a qualification test to verify that your
system meets the minimum requirements for installation. When qualification is
complete, a Results screen displays green flags next to system components that
meet requirements and red flags next to any that do not. If your system passes the
qualification, click Next. If any of your system components does not meet the
requirements, click View Report to identify them.
Setup now installs EasyConfigurator.
and any of the indicator LEDs are lighted. If they are not, see the
5