Publicidad
Idiomas disponibles
Idiomas disponibles
it straight forwards or back. Do not wiggle it from
side to side.
REMOVING THE
REFRIGERATOR DOORS
For some installations you need to remove the
fridge and freezer drawers so you can move the
refrigerator to its fi nal location. Do not remove
the doors/drawer if you don't need to. If you do
not need to remove the refrigerator doors, go to
Adjusting the Level on page 12. If you need to
remove the doors. continue below.
Before removing the door/drawer, make sure you
read the following items:
Required Tools (Not provided)
You need the following tools to complete the
installation of your refrigerator:
Philips
Flat-blade screw
screwdriver(+)
Allen wrench
Pliers
Disconnect power to the refrigerator before
removing the door or drawer.
WARNING
• Be careful not to drop, damage or
scratch the door/drawer while removing
them.
•
Be careful not to get injured while removing the
door/drawer.
•
Reattach the door/drawer properly to avoid:
-
Moisture from air leakage.
-
Uneven door alignment.
-
Wasting energy due to improper door seal.
10_ setting up
DA68-02615A(0.0).indb 10
DA68-02615A(0.0).indb 10
Socket wrench
driver(-)
(10 mm)
(5 mm)
Disassemble the refrigerator doors
Be careful not to drop and scratch the
doors while removing the doors.
WARNING
With the door opened
1.
Remove 3 screws holding down the TOP
TABLE ( 1 ) and turn it with wires connected.
1
2.
Disconnect two connector (
door. To remove the water coupler from the
hinge, twist and pull it from the hinge. Remove
the water line ( 3 ) while pressing the marked
part ( 4 ) of the water line coupler.
If a red clip is on the coupler, it must be
removed before removing the tube.
CAUTION
2
Red Clip
Red Clip
(1/4")
(1/4")
3
4
3.
Pull and remove the hinge lever (
the ground screw ( 6 ) attached to the upper
left door hinges with a philips screwdriver (+).
Remove the upper left and right door hinges
( 7 ).
5
7
2 ) on the left side
5 ) . Remove
6
2012.7.11 8:41:4 PM
2012.7.11 8:41:4 PM
Publicidad
