Teka DEP 90 Manual De Instrucciones página 6

Dear Customer,
Congratulations on your choice. We are
certain that this modern, functional and
lity materials will fully satisfy your require-
ments.
Please read all the sections in this INS-
TRUCTION MANUAL before using the
maximum performance from the device
and avoid faults which may arise from in-
correct use as well as minor problem sol-
ving.
For optimal performance, the external duct
should not exceed FOUR METRES, have
more than two 90 ° angles and its diameter
should be at least Ø120.
Safety Instructions
•Disconnect the device before
performing any work on the in-
terior, e.g. during cleaning or
maintenance.
•The excessive accumulation of
risks, therefore it is necessary to
wash the inside of the hood and
month.
•This device can be used by
children aged 8 and over and
persons with reduced physical,
sensory or mental capabilities or
lack of experience and knowled-
ge, if they have been given su-
pervision or proper training in
the safe use of the device and if
they understand the dangers in-
volved. Children should not play
with the device. Cleaning and
maintenance should be perfor-
-
med by the user and not by un-
supervised children.
•Check that the power voltage
and frequency match those in-
dicated on the label located on
the inside of the hood. A suita-
ble earth must be connected
(except for Class II devices,
marked with
data plate).
•For installation, a connection
installation should be incorpora-
ted, in accordance with installa-
tion regulations (adjusted to the
strength to be endured and with
a minimum opening between the
contacts of 3mm) under over-
-
voltage category III conditions,
for the emergency shutdown,
cleaning or light replacement. In
no event should the earth pass
through this switch. This switch
can be replaced with a plug if it
is accessible in normal use.
•If the power lead is damaged it
must be replaced by the manu-
facturer, its after-sales service
der to avoid potential danger.
•Air should not be extracted by
ducts used to expel fumes from
on the technical
-