Polaroid OneStep+ Manual De Instrucciones página 20

tripods. Simply screw your
tripod mount into the socket
on the base of the OneStep+.
Note with some tripods,
the tripod mount will need
to be unscrewed before
you can load or exchange
film into the OneStep+.
Cleaning the rollers
Sometimes excess developer
paste from photos may build up
on the camera's rollers, affect-
ing the camera's performance
and causing photos to show
unwanted imperfections. The
OneStep+ has a built-in roller
cleaning mode to help with this
issue. Just follow these steps:
1. Turn the camera off.
2. Open the film door.
3. Hold the flash override
button and press the shutter
button.
4. The camera is now in roller
cleaning mode.
5. Using a damp cloth or cot-
ton swab, gently clean the
rollers.
6. Press shutter button to
incrementally advance roller
positions.
7. Once both rollers are clean
on all sides, close the film
door.
8. Rollers will automatically
return to their correct
position.
Troubleshooting
& FAQ
My OneStep+ won't eject
my photo/darkslide
Make sure that your
OneStep+ camera is charged:
The camera's flash charge
LED will blink red if it doesn't
have enough charge to op-
erate. If this is the case, you
should recharge your camera
before using the camera
again.
Make sure you still have
film in your camera: to check,
slide the power switch off
and on. The remaining film
counter LEDs will indicate
how many shots you have left
in the film pack. If the LEDs
flash rapidly when the camera
turns on again, this means