General Information; App Compatibility; Cleaning; Kit Composition - Biasi Connect Manual De Instrucciones

General information

"BIASI Connect" kit is a WiFi "Connection device" that,
operating in the WLAN home
controlling the ambient thermoregulation and the
boiler's operation, both locally and remotely, by means
of a dedicated APP
This Section contains both the instructions for the
installation of "BIASI Connect" Kit and the instructions for
the configuration and use of the app to control the
system remotely using a smartphone
The APP/device can control the systems equipped with
this kit via web; the same system can be controlled by
means of several smartphones featuring the APP and
duly set with the Kit's credentials.
WARNINGS:
Carefully read the warnings included in this manual
•
"BIASI Connect" Kit is intended only for the use for
which it has been expressly designed, any other
use is to be consider as improper and dangerous
•
The installation of the appliance must be
performed ONLY by professionally qualified
personnel operating in compliance with the
national and local regulations in force, and with
the indications included in this manual
•
The manufacturer is not responsible for any
damage caused by:
Use contrary to the intended use or failure to
o
follow the indications in the instruction
manual and/or safety instructions;
Carelessness, accidents or normal wear;
o
External influences/agents (e.g.: damage
o
caused by vibrations, excessive heat, water,
humidity, acids, ...);
Use of unsuitable accessories;
o
Loss of the settings made by means of the
o
APP due to failed power supply, even
temporary, of the WFC device
•
If necessary, contact expert personnel also during
the installation and/or configuration of the APP or
network connections.
To ensure a correct operation of the appliance,
installation must be performed exclusively indoor, in dry
places far from strong electromagnetic fields.
•
The type of control that can be carried out by
means of "BIASI Connect" Kit is to be considered
as temporary The programming and general
control of the boiler are to be carried out by
means of the Remote Control (or the boiler's
control panel, in special cases).

APP compatibility

•
Smartphones with Android 4.4 or higher
•
Not compatible with tablets or other devices
other than Smartphones, even if equipped with
the correct Android version
•
iPhone, iPad e iPod touch with iOS 8.0 or higher
All product names, logos, and brands are property of their respective
owners. All company, product and service names used in this
document are for identification purposes only.
network, allows
P a g _ 11 | 36

Cleaning

It is possible to clean only the device's plastic coating.
Cleaning can be performed using a damp cloth It is
forbidden to use abrasive or powder detergents

Kit composition

•
n° 1 - "Module WFC01" (WiFi Control)
•
n° 1 - Power supply unit
•
n° 4 - Eyelets with screws for wall fixing
•
n° 2 - Expansion plugs with screws for wall fixing

Required accessories

This device works only in combination with the original
Remote Control Kit

Mechanical installation

Check that there is an adequate signal of the Wi-Fi
network at the installation point of the "Module WFC01"
and that there are no metal/conductive surfaces
nearby, since they may affect reception.

On DIN rail

The Connect Box can be installed on DIN rail, duly
preset For easy hooking and release, pull the indicated
black hook

On wall

Fit the plastic eyelets on the BOX body using screws,
then fix the "Module WFC01" to the wall using the
expansion plugs. All the above mentioned material is
supplied with the kit