Controls And Indicators Of The "Module Wfc01; System Control; Important; App Start-Up And Information - Biasi Connect Manual De Instrucciones

•
Release the R key; LEDs 4-5-6 start flashing
noticeably "randomly".
Note: after a Total reset, it is necessary to configure the
"Module WFC01" again
configuration on page 12)
Controls and indicators of the
"Module WFC01"
Description
Reset button
R
YELLOW:
1
OTM (boiler) connection status
OFF:
lack of communication with the boiler or open contact
ON:
regular communication with the boiler
FLASHING (quickly ½ sec.):
communication error with the boiler or the remote
control
FLASHING (slowly 2 sec.):
Request to the boiler in progress (generated from
APP+WFC or from Remote Control)
YELLOW:
2
OTS (remote control) connection status
OFF:
no connection (open contact)
ON:
regular communication with remote control
FLASHING (quickly ½ sec.):
Communication error with the boiler or the remote
control
FLASHING (slowly 2 sec.):
OTS contact closed (not provided for in this
application)
GREEN:
3
"Module WFC01" status
OFF:
normal operation
FLASHING (quickly ½ sec.):
Total reset in start-up phase
RED:
4
WiFi connection status
OFF:
Associated with WiFi network
(see "Module WFC01"
P a g _
Description
FLASHING (quickly ½ sec.):
NOT associated with WiFi network or (with LED 6 flashing
slowly) Hotspot activated
YELLOW:
5
WiFi data
FLASHING:
during data traffic on WiFi
GREEN:
6
TCP connection
ON:
TCP connection active
FLASHING (quickly ½ sec.):
No valid IP address or configuration mode
FLASHING (slowly 2 sec.):
Valid IP address (normal WiFi operation) or (with LED 4
flashing quickly) Hotspot activated
RED:
7
WiFi Control (WFC)
ON::
WFC active
temporarily, from APP+smartphone)
OFF:
the boiler status is determined from the Remote Control

System control

IMPORTANT: Remember that the default and main
control device of the system is always the Remote
Control and not the APP on the smartphone
The control through APP is always temporary (timed).
The system will always go back to the operation based
on the settings of the Remote Control at the end of the
activation time. The activation and timing can be
changed at any moment: see Activation and timing of
the device on page 16 for details.

APP start-up and information

•
At start-up, the APP shows the system's current
status (or the status of the last system/ "Module
WFC01" connected, if connections to several
devices have been configured)
•
Different system's values can be viewed and
edited, such as the set ambient temperature
•
A blank screen (data not shown) indicates that
the "Module WFC01" of the system is already
connected to another smartphone. After a very
short time, during which the APP tries to establish
a connection, the information that the device is
busy, is displayed
•
The APP is easy to use and intuitive. The function
of the main symbols/buttons is explained below
15 | 36
(the boiler status is determined,