HAMPTON BAY RIVERWALK 91142 Guía De Uso Y Mantenimiento página 7

Assembly - Standard Ceiling Mount
1
Preparing for standard mounting
□
Remove the canopy ring (K) from the canopy (C) by turning
the ring counterclockwise until it unlocks.
□
Remove the mounting bracket (A) from the canopy (C) by
loosening the two canopy screws (HH) located in the "L
shaped" slots.
□
Remove and save the two canopy screws (GG) in the round
holes. This will enable you to remove the mounting bracket
(A).
HH
3
Assembling the fan
WARNING: Failure to properly install the locking pin (CC)
could result in the fan becoming loose and possibly
falling.
□
Loosen, but do not remove, the setscrews (II) on the collar
on top of the fan-motor assembly (D).
□
Align the holes at the bottom of the ball/downrod assembly
(B) with the holes in the collar on top of the fan-motor
assembly (D).
□
Carefully insert the hanger pin (BB) through the holes in
the collar and ball/downrod assembly (B). Be careful not to
jam the hanger pin (BB) against the wiring inside the ball/
downrod assembly (B).
□
Insert the locking pin (CC) through the hole near the end of
the hanger pin (BB) until it snaps into its locked position.
□
Re-tighten the setscrews (II) on the collar on top of the fan-
motor assembly (D).
2
Routing the wires
□
Route the wires exiting the top of the fan motor
assembly (D) through the center of the canopy ring (K)
making sure the slots are on top.
□
Insert the ball/downrod (B) through the canopy (C) and
slide the decorative motor collar cover (F) onto the end
of the ball/downrod (B). Make sure the slots on the
canopy (C) are on top.
□
Route the wires existing the top of the fan motor
assembly (D) through the ball/downrod (B) as shown.
A
GG
C
K
7
BB
Please contact 1-855-HD-HAMPTON for further assistance.
C
K
B
F
D
C
K
B
F
CC
II
M
D
HAMPTONBAY.COM