General Information; Preparing The Appliance - Kärcher 2.642-347.0 Manual De Instrucciones

General information

Proper use
The telescopic spray lance can be used
with all Kärcher Home & Garden high-pres-
sure cleaners of the K2 to K7 classes.
It is not suitable for commercial use.
Spare parts
Only use original accessories and spare
parts, they ensure the safe and trouble-free
operation of the device.
For information about accessories and
spare parts, please visit www.kaerch-
er.com.

Preparing the Appliance

The following parts must be installed prior
to operation: High pressure hose, kink pro-
tection sleeve, intake for spray lance, carry-
ing belt and spray lance.
Mount the high pressure nozzle
onto the spray lance
Select the nozzle to match the high pres-
sure cleaner used.
K 2, K 3, K 4, K 5: Use brown high pres-
sure nozzle
K 6, K 7: Use white high pressure nozzle
(already installed)
Illustration
 Remove the clamp for the nozzle
mount.
First, loosen the clamp from below with
a small screwdriver.
 Pull out the unneeded high pressure
nozzle.
 Select the high pressure nozzle needed
to match the high pressure cleaner
used and press them in.
 Insert the clamp and secure the high
pressure nozzle.
Install high pressure hose, kink
protection sleeve and intake for the
Illustration
 Loosen the fastening nut and extend
the thin end of the pipe by about 30 cm.
Illustration
 Insert the kink protection sleeve onto
the end of the lance.
Illustration
 Insert the high pressure hose from the
bottom through the kink protection
sleeve and the lance until the high pres-
sure connection becomes visible at the
end of the lance (approx. 15 cm).
Illustration
 Pull the clamp out of the intake.
 Hold on to the high pressure hose and
slide the intake onto the high pressure
connection until it locks into place.
 Slide the intake all the way onto the
lance and turn it until the two holes are
aligned with the bores in the lance; then
press the clamp in and secure it.
Mount the high-pressure hose on
the hand spray gun
Illustration
Note: Disentangle the high pressure hose
and install it.
 Pull out the clamp for the high pressure
hose from the trigger gun.
 Connect high pressure hose to trigger
gun.
 Push the clamp in until it locks. Check
the secure connection by pulling on the
high-pressure hose.
Mount the spray lance
Illustration
 Push the spray lance all the way into the
adapter and fasten it by turning it by
90°.
Mount the carrying belt
Illustration
 Hook the carrying belt into the intakes.
– 2
EN
spray lance
9