Safety Information - Allen + Roth RDY1742-01-ORB Manual De Instrucciones

HARDWARE CONTENTS (Shown actual size)
AA
Wire
Connectors
Qty: 3

SAFETY INFORMATION

Please read and understand this entire manual before attempting to assemble, operate or install the
product.
WARNING:
• IMPORTANT: NEVER attempt any work without shutting off the electricity.
• Go to the main fuse, or circuit breaker, box in your home. Place the main power switch in the
"OFF" position.
• Unscrew the fuse(s), or switch "OFF" the circuit breaker switch(s), that control the power to
the fixture or room that you are working on.
• Place the wall switch in the "OFF" position. If the fixture to be replaced has a switch or pull
chain, place those in the "OFF" position.
• Do not use bulbs with wattage greater than specified on this fixture.
• WARNING: California Prop 65: This lighting fixture contains chemicals known to the state of
california to cause cancer, birth defects, and/or other reproductive harm. Wash hands after
use.
CAUTION:
• Read and understand all instructions and illustrations completely before proceeding with
assembly and installation of this fixture.
• If you have any doubts about how to install this lighting fixture, or if the fixture fails to operate
completely, please contact a qualified licensed electrical contractor.
• All parts must be used as indicated in these instructions. Do not substitute any parts, leave
parts out, or use any parts that are worn out or broken. Failure to obey this instruction could
invalidate the UL listing and/or C.S.A. certification of this fixture.
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with
package contents list and hardware contents. If any part is missing or damaged, do not attempt
to assemble the product.
Estimated Assembly time: 30 minutes to 1 hour.
Tools Required for Assembly (not included): Phillips screwdriver, flathead screwdriver, wire
strippers, electrical tape.
BB
Machine
Screws
Qty: 4
3
CC
Post
Screws
Qty: 3