Working Methods; General Working Instructions; Freeing Up A Jam - Deltafox DG-ESS 2844B Traducción Del Manual De Instrucciones Original

GB

Working methods

General working instructions

Keep enough distance to the
shredder since long branches
can be spun off while being
drawn into the shredder.
Wear ear and eye protection
Wear hand protection
• For safety reasons, the shredder will
not operate without a correctly at-
tached collector box (
safety switch (
• Keep hold of branches while feeding
them into the shredder until they are
automatically drawn in.
• To move the chopped material back,
only use the supplied plunger (
• Be aware of the possible intake speed
of the cutter and do not overload the
equipment.
• Keep to the working speed of the
shredder and do not overload it.
• To protect the shredder from clog-
ging, shred wilted garden waste
that has been left for a few days
and shred thin twigs alternately with
branches.
• Before you shred roots, remove any
remaining soil and stones from them
• Do not shred soft, damp material
such as kitchen waste, but take it
straight to the compost.
• Keep a few dry branches for the end,
as they will help clean the shredder.
• Only switch the shredder off when all
of the shredding material has passed
through the cylinder. Otherwise, the
cylinder may jam the next time you
switch the shredder on.
30
11)and the
A
A 14) is not locked.

Freeing up a jam

Changing the rotation direction:
1. Change the direction of rotation, as
described in the section "Operation/
Changing the direction of rotation (re-
verse)".
Jammed chopping material is released.
2. Change the direction of rotation again
to continue chopping (see chapter
"Operation / Switching on and off").
Change the distance of the pressure
plate:
For stubborn blockages, the distance of
the pressure plate (
cylinder (
1. Turn the adjusting screw (
clockwise.
2. Run the
18) wards as described under "Operation
/ Changing the rotation direction".
3. When the jammed chopping material
has been released, the pressure plate
( 24) must be readjusted by turning
the adjusting screw (
Exceptionally, if this process fails
to remove the blockage, the fol-
lowing option remains:
Unscrew housing plate
Blockages in the device can be removed
after unscrewing the housing plate.
Turn off the device and unplug the
power cord.
Wear protective gloves when
handling the blade cylinder
1. Remove the four hexagon so-
cket screws with snap ring (23)
from the housing plate (7).
24) from the blade
28) can be increased.
blade cylinder (
8) clockwise.
8) anti-
28) back-