Starting Operation - Bosch Professional GBH 36 V-LI Compact Manual Original

Dust Extraction with the Dust
Extraction Attachment (Accessory)
Dusts from materials such as lead-containing
coatings, some wood types, minerals and
metal can be harmful to one's health. Touch-
ing or breathing-in the dusts can cause aller-
gic reactions and/or lead to respiratory infec-
tions of the user or bystanders.
Certain dusts, such as oak or beech dust, are
considered as carcinogenic, especially in
connection with wood-treatment additives
(chromate, wood preservative). Materials
containing asbestos may only be worked by
specialists.
– Use dust extraction whenever possible.
– Provide for good ventilation of the work-
ing place.
– It is recommended to wear a P2 filter-
class respirator.
Observe the relevant regulations in your
country for the materials to be worked.
Mounting the Dust Extraction Attachment
(see figure G)
For dust extraction, the dust extraction attach-
ment (accessory) is required. When drilling, the
dust extraction attachment retracts so that the
attachment head is always close to the surface
at the drill hole.
Press the button for depth stop adjustment 9
and remove the depth stop 1. Press button 9
again and insert the dust extraction attachment
into the auxiliary handle 16 from the front.
Connect an extraction hose (diameter 19 mm,
accessory) to the extraction sleeve 20 of the
dust extraction attachment.
The vacuum cleaner must be suitable for the
material being worked.
When vacuuming dry dust that is especially
detrimental to health or carcinogenic, use a
special vacuum cleaner.
Adjusting the Drilling Depth on the Dust
Extraction Attachment (see figure H)
The required drilling depth X can also be adjust-
ed when the dust extraction attachment is
mounted.
Bosch Power Tools
Insert the SDS-plus drilling tool to the stop into
the SDS-plus tool holder 2. Otherwise, the mov-
ability of the SDS-plus drilling tool can lead to
incorrect adjustment of the drilling depth.
Loosen the wing bolt 24 on the dust extraction
attachment.
Without switching the power tool on, apply it
firmly to the drilling location. The SDS-plus drill-
ing tool must face against the surface.
Position the the guide pipe 25 of the dust ex-
traction attachment in its holding fixture in such
a manner that the head of the dust extraction at-
tachment faces against the surface to be drilled.
Do not slide the guide pipe 25 further over the
telescopic pipe 23 of the dust extraction attach-
ment than required, so that as much as possible
of the scale 23 on the telescopic pipe remains
visible.
Retighten the wing bolt 24 again. Loosen the
clamping screw 21 on the depth stop of the dust
extraction attachment.
Move the depth stop 22 on the telescopic pipe
23 in such a manner that the clearance X shown
in the figure corresponds with the required drill-
ing depth.
Tighten the clamping screw 21 in this position.
Operation

Starting Operation

Inserting the Battery
Use only original Bosch lithium ion batter-
ies with the voltage listed on the nameplate
of your power tool. Using other batteries can
lead to injuries and pose a fire hazard.
Set the rotational direction switch 6 to the cen-
tre position to protect the power tool against
accidental starting.
Insert the charged battery 11 from the front into
the base of the power tool. Push the battery
completely into the base until the red stripe can
no longer be seen and the battery is securely
locked.
English | 23
1 619 929 797 | (3.12.07)