Fowler Xtender-E PLUS Modo De Empleo página 14

9. Favourite key
E
The «favourite» key gives direct access to a predefined function, and can be configured according to the needs of the
user. In order to assign a function to the «favourite» key, give a prolonged press on
function :
0 dAtA
1 HoLd
2 CLr
Validation of selection: By a prolonged press on
Note : a function can also be assigned via RS232 using the command <FCT + Function No.>
example : Change of Unit = <FCT4>
Data
3 SEt
transmission
(defaut)
Hold display
4 Unit
Re-initialise
6 PrE
Min-Max-Delta
Zero
reset Diameter 7 ModE
calibration (min-
max-mode))
8 IntE
mm - IN
Recall Preset 9 toL
, or a short press on
14
, and then select the required
Nor-Min-Max-
10 rES
Delta
2 points Mode 11 dir
ON-OFF
12 Nul
Tol ON-Tol
OFF
13 bt
or
SET MODE
0.01 - 0.001
0.001 - 0.0001
Measurement
sense, positive-
negative