Fowler Xtender-E PLUS Modo De Empleo página 15

10. 2 points mode (Dynamic adjustment of the Preset)
This mode allow the diameter measurement with a CBG (Cylinder bore gage). It is indicated with the sign PRE.
Proceed as follows :
10.1 Calibration of the instrument
- Enter a Preset value corresponding to the actual size of the standard (see chap. 3)
- Enable the IntE Function. The MIN and the negative measurement sense are activated (default)
- Make a standard measurement (going through the turnaround point)
- Adjust the instrument by selecting the SEt mode and pressing on the button
- The instrument is adjusted and ready to measure.
10.2 Measurement
- Make the measurements. The digital display stores and displays the MIN (or MAX) measured value.
- Before each new measurement, reset the measured value by a short press on
15
(see chap. 3)
SET
E