ASROCK Z370 Extreme4 Manual De Instrucciones página 25

USB 3.1 Gen1 Headers
(19-pin USB3_5_6)
(see p.1, No. 7)
(19-pin USB3_7_8)
(see p.1, No. 8)
Front Panel Type C USB
3.1 Gen1 Header
(26-pin USB3_TC_1)
(see p.1, No. 9)
Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.1, No. 26)
1. High Definition Audio supports Jack Sensing, but the panel wire on the chassis must sup-
port HDA to function correctly. Please follow the instructions in our manual and chassis
manual to install your system.
2. If you use an AC'97 audio panel, please install it to the front panel audio header by the
steps below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for the HD audio panel only. You don't need to connect
them for the AC'97 audio panel.
E. To activate the front mic, go to the "FrontMic" Tab in the Realtek Control panel and
adjust "Recording Volume".
Vbus Vbus
Vbus IntA_PB_SSRX-
IntA_PA_SSRX- IntA_PB_SSRX+
IntA_PA_SSRX+ GND
GND IntA_PB_SSTX-
IntA_PA_SSTX-
IntA_PB_SSTX+
IntA_PA_SSTX+
GND
GND IntA_PB_D-
IntA_PA_D- IntA_PB_D+
IntA_PA_D+ Dummy
1
GND
PRESENCE#
MIC_RET
OUT_RET
1
OUT2_L
J_SENSE
OUT2_R
MIC2_R
MIC2_L
There are two headers on
this motherboard. Each
USB 3.1 Gen1 header can
support two ports.
There is one Front
Panel Type C USB 3.1
Gen1 Header on this
motherboard. This header
is used for connecting a
USB 3.1 Gen1 module for
additional USB 3.1 Gen1
ports.
This header is for
connecting audio devices
to the front audio panel.
Z370 Extreme4
23