Remote Control; Motorized Mount; Tripods; Other Accessories - Würth WLA08 Manual Del Usuario

WLA08-pg1-124 22/05/08 19:53
The remote can be used to stop or start rotation, increase or
decrease rotation speed, and move the beam or square shot. It also
controls scanning and electronic calibration.
• Specifications
Range*
Accuracy*
Battery life
Environmental
Size
* Varies with laser used. Actual accuracy depends on beam diameter and
distance to the laser.
**With batteries

7.2 Remote control

Remote window
5
4
Beam or
chalk line mode Scanning
1. 1. Scan On / Off
2. Decrease rotation 2. Decrease scan length
speed
3. Increase rotation 3. Increase scan length
speed
4. Move stationary point 4. Move scan left
or square shot left
5. Move stationary point 5. Move scan right
or square shot lright
24
Page 24
500 ft. (150 m) in detection mode
100 ft. (30 m) in remote mode
Fine ± <1/16" (1 mm)
Standard ± 1/8" (2.5 mm)
50 hours; 9V alkaline
Waterproof (IP66+)
6" x 3.25" x 1.5"; 10 oz**
(15 x 8 x 3.5 cm / 280 g**)
1
2
3
Battery location

Motorized Mount

1. Press 3 seconds to
activate wall mount
2. Move laser up
3. Move laser down
You cannot move the scan, plumb point, or slope in wall mount
mode. Exit this mode to use keys 4 & 5 for these functions.
The remote control can also be used for calibrating.
To open the battery compartment and change the battery, push
the battery cover in the direction of the arrow.

7.3 Tripods

The laser can be mounted on a 5/8-11 flat head tripod. You
can also use a tripod with an elevating column to adjust the
height of the laser.

7.4 Other accessories

1. Laser-enhancing glasses improve the visibility of the laser
beam in bright light conditions.
2. Red magnetic target improves the visibility of the laser beam
in bright conditions. Quickly attaches to any metallic surface.
Warranty
The manufacturer warrants its measuring instruments against all
manufacturing defects for a period of one year from date of
purchase. If during the warranty period, the product is consid-
ered as defective by the manufacturer, the latter will decide
whether to repair or exchange the product. The only obligation
and sole recourse of the buyer will be limited to this repair or
exchange.
The manufacturer, the distributor or the retailer will in no case
be responsible for any incident or consequence, damage, etc.
relative to the use of those instruments.
Limits and exclusions: the warranty will not apply to any dam-
age resulting from negligence, accident, misuse, repair or stor-
age or in case of abnormal use.
GB F E D I N FIN
25