Care And Handling; Warranty; Accessories - Würth WLA08 Manual Del Usuario

WLA08-pg1-124 22/05/08 19:53

5. Care and Handling

CAUTION
Using of controls or adjustments of procedures other than those
specified herein may result in hazardous radiation exposure.
The WLA08 is a precision instrument which must be handled with
care. Avoid shock and vibrations. Always store and transport the
laser and its accessories in the carrying case.
Although weather resistant, you must always keep your laser and its
accessories dry and clean after using. This will increase the battery life.
Do not store your laser at temperatures below -4°F (-20°C) or
above 176°F (80°C) because some electronic components could
be damaged.
Do not store your instrument in its case if the instrument or the case
are wet, to avoid water condensation inside the instrument.
To maintain the precision of your WLA08 check and adjust it regularly.
Keep the lenses of the apertures dry and clean. Use a soft cloth
and glass cleaner to clean them.
We recommend to regularly charge the batteries of the WLA08.
Nevertheless, make sure to charge them only when they are out of
power or becoming so. Recharging batteries that are still useable
will shorten their capacity.

6. Warranty

The WLA08 laser is guaranteed to be free of manufacturing defects
for a period of one year. Any abnormal usage or if the instrument
has been subjected to shock will void this warranty. Under no cir-
cumstances will the liability of the manufacturer exceed the cost of
repairing or replacing the instrument.
Disassembling the instrument by other than qualified and certified
technicians will void this warranty.
Specifications subject to change without notice.
20
Page 20

7. Accessories

7.1 Combination detector and
laser remote control
For grade rod or handheld applications. Also can use the magnet
mount to attach to metal studs for exterior curtain wall alignment or
to ceiling grids for acoustical ceiling leveling.
Magnet Window for remote's
infrared signal
Level vial
LCD
screen
(front)
Detection
window
Turn to attach
clamp to
detector
Turn to tighten
or remove clamp
from rod
GB F E D I N FIN
On-grade
alignment notch
LCD screen
(rear)
Bubble
vial to
plumb rod
9V battery
compartment
(follow polarity
indications inside)
Use a coin to unscrew
the battery cap
21