Technical Data; General Power Tool Safety Warnings - Parkside PEH 30 C3 Traducción Del Manual De Instrucciones Original

Technical data

Rated voltage
Nominal output
Rated idle speed
Plane width
Cut depth
Fold depth
Protection class
Noise and vibration data
Noise measurement value determined in accordance
with EN 62841. The A-rated noise level of the
power tool is typically as follows:
Noise emission value
Sound pressure level
Sound power level
Uncertainty
Wear hearing protection!
Total vibration value
Handle
Additional handle
Uncertainty
NOTE
► For an accurate estimate of the vibration load
during a specific working period, the periods
during which the appliance is switched off or
is running but not actually being used must
also be taken into consideration. This can
significantly reduce the vibration load over
the total working period.
► The vibration emission values and the noise
emission values given in these instructions
have been measured in accordance with a
standardised test procedure and can be used
for comparison of the power tool with
another tool.
PEH 30 C3
230 V ∼, 50 Hz (AC)
750 W
n 13000 rpm
0
82 mm
0–3 mm
max. 24 mm
II / (double insulation)
L = 97 dB(A)
PA
L = 108 dB(A)
WA
K = 3 dB
a = 10.8 m/s 2
h
a = 8.8 m/s 2
h
K = 1.5 m/s 2
NOTE
► The specified total vibration values and the
noise emission values can also be used to
make a provisional load estimate.
WARNING!
► Depending on the manner in which the
power tool is being used, and in particular
the kind of workpiece that is being worked,
the vibration and noise emission values can
deviate from the values given in these instruc-
tions during actual use of the power tool.
Try to keep the vibration loads as low as
possible. Measures to reduce the vibration
load are, e.g. wearing gloves and limiting the
working time. Wherein all states of operation
must be included (e.g. times when the power
tool is switched off and times where the power
tool is switched on but running without load).
General power tool
safety warnings
WARNING!
► Read all safety warnings, instructions,
illustrations and specifications provided
with this power tool. Failure to follow all
instructions listed below may result in electric
shock, fire and/or serious injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to
your mains-operated (corded) power tool or battery-
operated (cordless) power tool.
GB │ MT │
45 ■