Würth BS 14-A Power Traducción Del Manual De Instrucciones De Servicio Original página 11

OBJ_BUCH-1566-002.book Page 11 Tuesday, July 23, 2013 12:57 PM
 Use appropriate detectors to determine if util-
ity lines are hidden in the work area or call the
local utility company for assistance. Contact with
electric lines can lead to fire and electric shock. Damaging
a gas line can lead to explosion. Penetrating a water line
causes property damage.
 Switch off the power tool immediately when
the tool insert jams. Be prepared for high reac-
tion torque that can cause kickback. The tool
insert jams when:
– the power tool is subject to overload or
– it becomes wedged in the workpiece.
 Hold the machine with a firm grip. High reaction
torque can briefly occur while driving in and loosening
screws.
 Secure the workpiece. A workpiece clamped with
clamping devices or in a vice is held more secure than by
hand.
 Keep your workplace clean. Blends of materials
are particularly dangerous. Dust from light alloys can burn
or explode.
 Do not open the battery. Danger of short-circuiting.
Protect the battery against heat, e. g.,
against continuous intense sunlight, fire,
water, and moisture. Danger of explosion.
 In case of damage and improper use of the
battery, vapours may be emitted. Ventilate
the area and seek medical help in case of com-
plaints. The vapours can irritate the respiratory system.
 Use the battery only in conjunction with your
Würth power tool. This measure alone protects the
battery against dangerous overload.
 Use only original Würth batteries with the volt-
age listed on the nameplate of your power
tool. When using other batteries, e. g. imitations, recon-
ditioned batteries or other brands, there is danger of injury
as well as property damage through exploding batteries.
Additional Safety and
Working Instructions
 Dusts from materials such as lead-containing
coatings, some wood types, minerals and
metal can be harmful to one's health and
cause allergic reactions, lead to respiratory
infections and/or cancer. Materials containing
asbestos may only be worked by specialists.
• Provide for good ventilation of the working place.
• It is recommended to wear a P2 filter-class respirator.
Observe the relevant regulations in your country for the
materials to be worked.
 To save energy, only switch the power tool on when using
it.
 Before any work on the machine (e. g., main-
tenance, tool change, etc.) as well as during
transport and storage, set the rotational direc-
tion switch to the centre position. Unintentional
actuation of the On/Off switch can lead to injuries.
 The battery is supplied partially charged. To
ensure full battery capacity, completely
charge the battery in the battery charger
before using for the first time.
 The battery is equipped with a NTC tempera-
ture control which allows charging only within
a temperature range of between 0 °C and
45 °C. A long battery service life is achieved in
this manner.
 Read the operating instructions of the battery
charger.
 Apply the power tool to the screw only when
it is switched off. Rotating tool inserts can slip off.
 Adjust the gear switch only when the machine
is at a complete stop.
 Always push the gear selector and turn the
operating mode selector switch through to the
stop. Otherwise, the machine can become damaged.
 In case of excessive loading, e. g., prolonged
blocking of the application tool, the electronics
switch off the power tool. After switching on
again, the power tool can be used again as
intended for. In case of continued overload,
the power tool will switch off again in order to
prevent damage to the motor.
 Use only original Würth accessories.
Symbols
The following symbols are important for reading and under-
standing the operating instructions. Please take note of the
symbols and their meaning. The correct interpretation of the
symbols will help you to use the machine in a better and safer
manner.
11