Directions For Use - brennenstuhl Multi-Test MT 6 S/2 Instrucciones De Empleo

013109 Multi-Test MT 6 S_2_013109 BA_Multi-Test MT 6_S 01.04.16
Operating Instructions
Important Notice:
1) This testing device is only suitable for use in dry
rooms and my not be used for voltages above the
specified values.
2) Operate only at ambient temperatures -10°C and
+50°C and in the frequency range between 50 and
500 Hz.
3) The sensitivity of the display can be impeded by un-
favourable lighting conditions, e.g. strong sunlight
or by unfavourable locations, e.g. wooden steplad-
ders or insulating carpet padding and in alternating
current nets that are not properly grounded.
4) The testing device must be tested for proper
function prior to first use (self test).
5) The testing device may not be used in damp
conditions (e.g. dew or rain).
6) The testing probe is only designed to perform
voltage tests. Do not attempt to perform other work
on voltage-carrying appliances or devices with it.
7) Defective testers, whose function and/or safety is
obviously impaired, may not be used.
8) The tester can acquire a static charge from friction
and then produce false readings.
9) Never attempt to alter any internal components of
this tester.
10)These instructions contain important safety infor-
mation. Store these instructions with the device.
11) To clean the tester, use a damp cloth but never use
scouring agents or solvents.
12) If the tester is used for purposes other than those
intended by the manufacturer, the safety functions
of the device can be impeded.
13) In cases of doubt, please contact a qualified
technician.
Inserting the Batteries
Remove the screw by turning counter-clockwise.
Insert the three button cells, negative pole first into the
battery compartment and then re-tighten the screw.
Battery type: 3 button cells 1.5V (392A, AG3, LR41,
V3GA, G3-A or similar).
7